Projection Geometric Corrector

   TK-1S projector geometric corrector with 1BNC,1VGA,1HDMI,1DVI input and 1 DVI-I,HDMI(compatible VGA),1 DVI output.

Sketch:

 In recently years, there have been showing a sharply rising trend of using ARC projection for the more and more demand of personalized video project. In the past ,user use edge fusion processor to surface modification of image when using a single projector cast arc projection screen . It can not only increase cost excessively ,but also It's hard to master the complex debug method of edge fusion processor for user.

  In order to adapt the market , Tuukoo push out TK-1S projector surface orthotics. The main function of TK-1S is aim at surface modification of single projector cast arc screen  to make sure the video image just right fully display on projection screen, display a excellent video image.

 Comparing with traditional corrector,TK-1S arc corrector can not only realize curved screen correct, but also can support multi input signal. What's more ,It's the one and only can support active 3D arc correction with 120HZ.

Product Introduction

Signal interface

1, 1 multiplexed video BNC, 1 VGA, 1 HDMI

2,  1 DVI-1 and 1 HDMI output, HDMI and VGA are compatible, connecting need projector to be correction;

3,  Two groups of the output signals can be setting ring out ,another to connect the main projector to arc correction;

4,  1 RS-232 serial port, IP control local area network ;

the resolution:

1,   Input resolution support 640*480 to 1920*1200 and automatic identification

2,  Output resolution optional support 720*480, 1280*720, 1920*1080, 800*600, 1024*768, 1280*800, 1280*1024,1360*768,1400*1050,1600*1200,1920*1200;

Correction

 TK-1S arc correction trapezoidal and arc correction projected image by visual operation interface; After adjustment the projection screen surface for the first time, It can be use after booting ,no need to debug again.